Creation date / 2017 / November
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30
- 1. Starting with a clay model, so I can figure out the shape to cut out of the sheet of brass.
- 2. The clay model was dipped in molten Dip Seal. The Dip Seal was cut and opened up and used to make a paper pattern.
- 3. I wanted the finished piece to be larger than the clay model, so I scanned the first paper pattern and reprinted it in the size I wanted.
- 4. The larger paper pattern was cut out and traced onto a piece of 16 gauge brass sheet, which was then cut out and annealed.
- 5. This form requires a lot of stretching, so I'm starting out by pushing out with a large ball on a polyurethane pad with the hydraulic press.
- 6. Using the raising hammer and stake to continue the forming toward the perimeter.
- 7. Hammering the ears to stretch them around the curve where they meet the head.
- 8. Using the stake shown in the inset to stretch the outer part of the curve of the trunk.