- Pod1
- Pod2
- Pod3
- Pod4
- The Finished Piece
- 1. The blank cut out of 16 gauge brass.
- 2. Starting the forming on the sand bag.
- 3. starting the cylindrical curve of the end pieces on a wood V-block.
- 4. Completing the cylindrical curve on a flat stake.
- 5. Forming/planishing over a stake from the outside.
- 6. What it looks like so far. It is ready to be annealed so the metal will be soft enough to work some more.
- 7. After annealing, putting a trough down the middle.
- 8. On the outside, that trough is a ridge.
- 9. Forming the places where the "seeds" will go.
- 10. There it is, forming complete except for curving the ends.