Recent Work

From Most recent, going back to 2014

[ stop the slideshow ]

4. The larger paper pattern was cut out and traced onto a piece of 16 gauge brass sheet, which was then cut out and annealed.

04a.jpg 4. The top piece gets a hole drilled and tapped to receive the threaded inflation tube.Thumbnails4. I didn't get pictures of a lot of the earliest forming. All the pointed parts have been formed, using the technique shown in picture #7. Here I am using the ball stake shown in the inset to round out the body.4. The top piece gets a hole drilled and tapped to receive the threaded inflation tube.Thumbnails4. I didn't get pictures of a lot of the earliest forming. All the pointed parts have been formed, using the technique shown in picture #7. Here I am using the ball stake shown in the inset to round out the body.4. The top piece gets a hole drilled and tapped to receive the threaded inflation tube.Thumbnails4. I didn't get pictures of a lot of the earliest forming. All the pointed parts have been formed, using the technique shown in picture #7. Here I am using the ball stake shown in the inset to round out the body.4. The top piece gets a hole drilled and tapped to receive the threaded inflation tube.Thumbnails4. I didn't get pictures of a lot of the earliest forming. All the pointed parts have been formed, using the technique shown in picture #7. Here I am using the ball stake shown in the inset to round out the body.4. The top piece gets a hole drilled and tapped to receive the threaded inflation tube.Thumbnails4. I didn't get pictures of a lot of the earliest forming. All the pointed parts have been formed, using the technique shown in picture #7. Here I am using the ball stake shown in the inset to round out the body.

4. The larger paper pattern was cut out and traced onto a piece of 16 gauge brass sheet, which was then cut out and annealed.