Recent Work

From Most recent, going back to 2014

Home / Recent Work / Magnifier, hammer-formed brass with purchased lens, 5.5" x 11" x 1" / Magnifier, how it was made /

2. The clay model has been dipped in molten Dip Seal, then the Dip Seal rubbery coating cut with a sharp knife and removed.

02a.jpg 11. The last part of the seam has been silver-soldered.Thumbnails6. After first silver-soldering, I continue spiraling it around. Here is a special stake that I made, shown at the top, for forming this part of it.11. The last part of the seam has been silver-soldered.Thumbnails6. After first silver-soldering, I continue spiraling it around. Here is a special stake that I made, shown at the top, for forming this part of it.11. The last part of the seam has been silver-soldered.Thumbnails6. After first silver-soldering, I continue spiraling it around. Here is a special stake that I made, shown at the top, for forming this part of it.11. The last part of the seam has been silver-soldered.Thumbnails6. After first silver-soldering, I continue spiraling it around. Here is a special stake that I made, shown at the top, for forming this part of it.
Author
Steve Shelby
Visits
4204

EXIF Metadata

Make
NIKON CORPORATION
Model
NIKON D60
DateTimeOriginal
2019:02:05 21:04:28
ApertureFNumber
f/4.5

0 comments