Recent Work

From Most recent, going back to 2014

Home / Recent Work / Magnifier, hammer-formed brass with purchased lens, 5.5" x 11" x 1" / Magnifier, how it was made /

2. The clay model has been dipped in molten Dip Seal, then the Dip Seal rubbery coating cut with a sharp knife and removed.

02a.jpg 1. Starting with a sketch and a clay model of the handle.Thumbnails3. The rubbery pattern has been spread flat and traced onto paper, the resulting paper pattern then traced onto 81 gauge brass sheet.1. Starting with a sketch and a clay model of the handle.Thumbnails3. The rubbery pattern has been spread flat and traced onto paper, the resulting paper pattern then traced onto 81 gauge brass sheet.1. Starting with a sketch and a clay model of the handle.Thumbnails3. The rubbery pattern has been spread flat and traced onto paper, the resulting paper pattern then traced onto 81 gauge brass sheet.1. Starting with a sketch and a clay model of the handle.Thumbnails3. The rubbery pattern has been spread flat and traced onto paper, the resulting paper pattern then traced onto 81 gauge brass sheet.
Author
Steve Shelby
Visits
4202

EXIF Metadata

Make
NIKON CORPORATION
Model
NIKON D60
DateTimeOriginal
2019:02:05 21:04:28
ApertureFNumber
f/4.5

0 comments