Home / Keyword hammered metal 852
- 5. The seam is silver-soldered a little bit at a time.
- 4. Starting the forming process.
- 3. The rubbery pattern has been spread flat and traced onto paper, the resulting paper pattern then traced onto 81 gauge brass sheet.
- 2. The clay model has been dipped in molten Dip Seal, then the Dip Seal rubbery coating cut with a sharp knife and removed.
- 1. Starting with a sketch and a clay model of the handle.
- finished2
- finished1
- 26a
- Finished!
- 33. The feet put into place.
- 32. The head secured with two screws.
- 31. The hand secured with a screw.
- 30. The three parts ready to be installed.
- 29. A brass rod silver-soldered to the feet. it will fit tightly into a hole drilled in the wood.
- 28. Straps of brass have been silver-soldered to the head, so it can be fastened invisibly to the interior of the wood.